CORNER SEAT BOX FURNITURE DIY

Requirements:

The same as for the Window-seat, with the addition of two boxes supported on legs, as follows:

 Seat.

1 Soap Box (about 8 8/4 in. deep, 15 1/2 in. wide, 20 1/2 in. long). 

End Support.

1 Candle Box (about 10 8/4 in. deep, 12 1/2 in. wide, 16 in. long).

Legs.

8 Strips 8/8 in. thick, 1 8/8 in. wide, 18 1/4 in. long. 8 Strips 8/8 in. thick, 1 8/4 in. wide, 18 1/4 in. long. 

Seat Cover.

1 Piece 8/4 in. thick, the width equal to the outside Width of the ell seat box, and length equal to the outside length of the box.

Construction: 

Make two Flower and Book-Stands, and provide slot opening in one to receive the seat; also provide a seat support as described for the Window seat. Make the legs  18 1/4 inches long. Remove the covers. Nail a leg on the corner of each box,  each box, allowing them to project below the bottom, having their other ends even with the open top end. Make a cover for the box which is to form the ell portion of the seat, putting a cleat near each end on the under side. This box will form the short or ell portion of the seat and will stand at a right angle to the long portion of the seat, with one flower-stand at its outer end. The cover of the box will form the seat and will not be hinged. The end of the long seat will be supported by a box placed under it in the corner.